Filter
Top Products
13
Canceling a Cycle
Anytime during a cycle, press
CANCEL/DRAIN glows. The dishwasher pauses for about
5 seconds and starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light goes off when the
dishwasher finishes the drain.
To stop the drain
You can press Cancel/Drain again to stop the drain
immediately. Remember to drain the dishwasher before
starting a new cycle.
NOTE: A small amount of water remains in the dishwasher.
This is normal.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear
all options and cycles.
Option Selections
You can customize your cycles by pressing an option. If
you change your mind, press the option again to turn the
option off. Select a different option if desired.
You can change an option anytime before the selected
option begins. For example, you can press an unheated
drying option any time before drying begins.
After a wash cycle, the dishwasher remembers the options
used and uses the same options in the next wash cycle,
unless you select new options or press Cancel/Drain.
High Temp Wash
Select this option to heat the water to 140°F (60°C) in the
main wash cycle. This option adds heat and wash time to
the parts of the cycle. Heating the water helps improve
washing results.
NOTE: The Heavy and Pots-N-Pans cycles automatically
use this option. High Temp Wash is an option with the Low
Energy and Normal cycles.
Air Dry
Select this option to dry dishes without heat and save
energy. The dishes take longer to dry and some spotting
can occur.
For best drying, use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE: The dishwasher automatically heats the air in the
dishwasher during the “dry” portion of the cycle unless
you select Air Dry.
Delay Hours
Select this option to run your dishwasher at a later time or
during off-peak hours. You can add items to the load
anytime during the delay countdown. After adding items,
close the door firmly until it latches. The delay countdown
will not continue if the door is not latched.
To delay the start
1. Close the door.
2. Press DELAY HOURS 1 time for a 2-hour delay, 2 times
for a 4-hour delay, or 3 times for a 6-hour delay start.
3. Select a wash cycle and option(s).
The number glows above Delay Hours. The dishwasher
starts the cycle in the selected number of hours. If you do
not press a cycle within 30 seconds the Delay Hours
indicator turns off.
NOTES:
■ To cancel the delay and cycle, press CANCEL/DRAIN.
■ To cancel the delay and start the cycle, press DELAY
HOURS until 6 glows. Then press DELAY HOURS one
more time. The delayed cycle starts.
IMPORTANT:
■ Operate your dishwasher only when you are at home.
■ If your home is equipped with a water softener, do not
start the dishwasher during the regeneration of the
softener.
CANCEL
DRAIN
HIGH
TEMP
WASH
AIR DRY
DELAY
HOURS