Filter
Top Products
6
GETTING STARTED
INSTALLATION CHECKLIST
✔ Electrical Power
❑ Plug refrigerator into a grounded 3 prong outlet.
✔ Doors
❑ If doors need to be removed during installation, see the
“Remove and Replace Doors” section in the instructions.
❑ Check that handles are secure and installed according to the
instructions.
❑ Doors seal completely.
❑ Refrigerator is level. (Remove base grille and adjust leveling
feet so they are snug against the oor.)
❑ Doors are even across the top. (Use door alignment feature if
necessary.)
❑ Base grille is properly attached to the refrigerator.
✔ Ice and Water System (on some models)
❑ Connect refrigerator to a cold water supply with 20-120 psi
water pressure, as specied in the instructions.
❑ Make sure the household water supply is connected and
turned on.
❑ Check that the water supply line behind refrigerator is not
kinked.
❑ Only use recommended water supply tubing, copper, or PEX,
as specied in the instructions.
❑ Install water lter according to the instructions.
❑ Flush water system with 3 gallons of water, as specied in the
instructions.
❑ Check for water leaks at all connections.
❑ Turn on ice maker if refrigerator is connected to water supply.
(If not connected to water supply, turn off ice maker.)
✔ Final Checks
❑ Install air lter and Produce Preserver according to
instructions in corresponding packaging.
❑ Remove all shipping material.
❑ Set temperature controls to the recommended setting.
❑ Save instructions and other literature.
❑ Send in registration card or register your product online.
WATER FILTER INSTALLATION
❑ Locate the water lter compartment in the lower left-hand side
of the refrigerator compartment. Push on the right side of the
lter door to open.
❑ Align the arrow on the water lter cap with the cutout notch in
the lter housing and insert lter.
❑ Once the lter is inserted, turn the lter clockwise 90° (¼ turn)
until it locks into the housing.
❑ Push water lter door closed to latch.
❑ Flush 3 gallons of water through the water system to clear air
from the water line and to keep the dispenser from dripping
and/or avoiding decreased dispenser ow.
NOTE: If the lter is not installed correctly, water may
dispense at a lower ow rate and there will be slower ice
production. Improper lter installation may also cause the
water lter housing to leak.
To view videos on door removal/
replacement, door adjustment, water
filter installation, air filter installation,
shelf adjustment or removal, and Wi-Fi
(if applicable) connectivity, scan the code
to the left with your mobile device.
Fingerprint-Resistant Steel and Black Stainless Steel
(on some models)
A specialized coating for stainless steel that resists smudges,
fingerprints, and water marks. It is easy to clean with just water
and a towel.
LED Lighting
There is bright LED strip lighting for maximum illumination.
LED lights do not require replacement.
Door Alarm
A helpful alarm sounds when the refrigerator door or freezer
drawer is left ajar.
Power Outage Indicator
If the power should go out while you are away from home, this
indicator will let you know that the refrigerator has been without
power.