Filter
Top Products
Noise
Temperature and Moisture
The lights do not work A light bulb is loose in the socket or
burned out
Tighten or replace the light bulb. See “Changing the Light
Bulbs.”
The dispenser light is set to OFF On some models, the dispenser light will operate only when a
dispenser paddle is pressed. If you want the dispenser light to
stay on continuously, see “Water Dispenser.”
The control is set to Sabbath Mode (on
some mo
dels)
Turn off Sabbath Mode. See “Using the Controls.”
PROBLEM POSSIBLE CAUSES SOLUTIONS
The refrigerator seems
noisy
Below are listed some normal
sounds with explanations.
The compressor in your new refrigerator regulates
temperature more efficiently while using less energy, and
operates quietly. Due to the reduction in operating noise you
may notice more intermittent noises.
Sound of the compressor
running longer than expected
hTsnaf dna rosserpmoc ycneiciffe hgiH is is normal. Larger, mo
re efficient
refrigerators run longer.
Pulsating/Whirring Fans/compresso
r adjusting to optimize performance during
normal compressor operation
This is normal
edisni fo noisnapxe/noitcartnoCgnippoP walls, especially during initial
cool-down
This is normal
Hissing/Dripping Flow of refrigerant, or flow of oil in the compressor This is normal
aets eb ton yam rotaregirfer ehTnoitarbiV rewol dna swercs gnilevel eht tsujdA
yd
the leveling foot firmly against the floor.
See “Door Closing and Door
Alignment.”
Rattling/Banging Movement of the water lin
es against the refrigerator cabinet,
or of items placed on top of the refrigerator cabinet
Move excess water line away from the
refrigerator cabinet or fasten excess
tubing to the cabinet. See “Connect
the Water Supply,” or remove items
from the top of the refrigerator.
lamron si sihTe
lcyc tsorfed gnirud retaeh eht no gnippird retaWgnilzziS
Water running/Gurgling May be heard when ice melts during the defrost cycle and
water runs into the drain pan
This is normal
lamron
si sihTrekam eci eht llif ot snepo evlav retaw eht nehw draeHgnizzuB
Creaking/Cracking May be heard as ice is being ejected from the ice maker mold This is normal
Ker-plunk May be heard when the ice falls into the ice storag
e bin This is normal
PROBLEM POSSIBLE CAUSES SOLUTIONS
Temperature is too warm The refrigerator has just been installed Allow 24 hours following installation for the refrigerator to cool
completely.
Cooling is turned off Turn on cooling. See “Using the Controls.”
The controls are not set correctly for
the surrounding conditions
Adjust the controls a setting colder. Check the temperature in
24 hours. See “Using the Controls.”
The door(s) are opened often or
not
closed completely
Allows warm air to enter refrigerator. Minimize door openings
and keep doors fully closed.
A large load of food was recently
added
Allow several hours for refrigerator to return to normal
temperature.
PROBLEM POSSIBLE CAUSES SOLUTIONS
19