KitchenAid KRFF707ESS Refrigerator User Manual


 
34
TROUBLESHOOTING
Ice and Water
There is interior moisture
buildup
NOTE: Some moisture
buildup is normal.
The room is humid A humid environment contributes to moisture buildup.
The door(s) are opened often or not
closed completely.
Allows humid air to enter the refrigerator. Minimize door
openings and close doors completely.
The door is blocked open Move food packages away from door.
A bin or shelf is in the way Push bin or shelf back into the correct position.
Storing liquid in open containers This adds humidity to the refrigerator interior. Keep all
containers tightly covered.
There is frost/ice buildup in
the freezer compartment
The drawer is opened often or left
open.
Minimize drawer openings and close drawer completely after
use.
eht htiw tcatnoc lluf g
nikam era slaes rood erusnE laes rood rooP
refrigerator cabinet to allow for an adequate seal.
Temperature controls are not set
correctly
See “Using the Controls” for recommended temperature
settings.
PROBLEM POSSIBLE CAUSES SOLUTIONS
The ice maker is not
producing ice or is not
producing enough ice
The refrigerator is not connected to a
water supply or the water supply
shutoff valve is not turned on.
Connect refrigerator to water supply and turn water shutoff
valve fully open.
There is a kink in the water source line. A kink in the line can reduce water flow. Straighten the water
source line.
The ice maker is not turned on. Make sure the ice maker is on. See “Ice Maker and
Ice Storage Bin.”
T
he refrigerator has just been
installed.
Wait 24 hours after ice maker installation for ice production
to begin. Wait 3 days for full ice produ
ction.
The refrigerator door is not closed
completely.
Close the door firmly. If it does not close completely, see
“The doors will not close completely.”
A large amount of ice was recently
removed.
Allow sufficient time for ice maker to produce more ice. See
“Ice Maker and Ice Storage Bin” for ice production rates.
An ice cube is jammed in the ice
maker ejector arm.
Remove ice from the ejector arm with a plastic utensil.
A water filter is installed on
the
refrigerator.
Remove the water filter and operate the ice maker. If ice
volume improves, then the filter may be clogged or
incorrectly installed. Replace filter or reinstall it correctly.
A reverse osmosis water filtration
system is connected to your cold
water supply.
This can decrease water pressure. See “Water Supply
Requirements.”
PROBLEM POSSIBLE CAUSES SOLUTIONS
Temperature is too cold in
the refrigerator/crisper
The refrigerator air vent(s) are blocked. If the air vent located in the
top, left, rear corner of the
refrigerator compartment is blocked by items placed directly
in front of it, the refrigerator will get too cold. Move items
away from the air vent.
The controls are not set correctly for
the surrounding conditions.
Adjust the controls a setting warmer. Check the temperature
in 24 hours. See “Using the Controls.”
The ice storage bin is not in the
correct position.
See “Ice Maker and Ice Storage Bin.”
Temperature is too cold in
the pantry drawers
The control is not set correctly for the
items stored in drawer.
Adjust the temperature setting. See “Temperature Controlled
Drawer” in the “Refrigerator Features” section.