Open as PDF
Backer and Spacer Panel Dimensions
NOTE: The dashed lines represent the placement of the backer
and spacer panels on the decorative panels. Backer and spacer
panels should be centered vertically and horizontally.
Install the Door Panels
NOTE: In the graphics throughout this section, dark gray
represents the door trim and light gray represents the door panel.
1. Remove the upper trim from the top of the freezer door.
2. Remove the side trim from each side of the freezer door.
3. Align the bottom edge of the door panel with the lower trim on
the bottom of the freezer door. Center the panel on the freezer
4. Reseat each side trim, making sure the trim clip slides inside
the corner of the lower trim.
Dimension Backer Panel Spacer Panel
A 19" (48.3 cm) 18³⁄₈" (46.7 cm)
B 31¹⁵⁄₃₂" (79.9 cm) 30³⁄₄" (78.1 cm)
C 67²⁹⁄₃₂" (172.5 cm) 66⁹⁄₁₆" (169.1 cm)
D 14⁷⁄₈" (37.8 cm) 14¹⁄₄" (36.2 cm)
E 19¹⁄₂" (49.6 cm) 18⁷⁄₈" (47.9 cm)
A. Trim clip