Filter
Top Products
18
. FROTHING MILK FOR A CAPPUCCINO
When preparing an espresso, this machine
can be used to produce frothy milk to prepare
a cappuccino.
For best results, use the cappuccino accessory.
Please note: The cappuccino accessory
must only be used for producing frothy
milk.
•Fit the accessory to the end of the steam
nozzle (17).
•Pour about 200 ml of skimmed milk into a
small high-sided container (maximum
capacity 0.5 L) which will fit beneath the
steam nozzle.
The milk must be nice and fresh, and the
container must also be chilled, so do not rinse
it in hot water beforehand.
• Check that the boiler is full of water.
The pump switch must be in position
(18).
When the yellow temperature indicator light
goes out:
• Place a container under the steam nozzle
and turn the steam tap to max position.
•Let the water flow until steam appears, then
turn the tap back to position O.
You can now start to prepare frothy milk.
• Place a container under the steam nozzle in
such a way that it is completely immersed in
the milk.
• Turn the tap slowly to max position and
hold the container steady during the
operation (19).
The nozzle must not touch the bottom of the
container so as not to prevent the steam
escaping.
• Once you have obtained the froth, reset the
tap to position O and remove the container.
• Then set the tap to steam position again for
a few moments (with an empty container
under the nozzle) to eliminate the residue of
milk in the nozzle.
• Once this operation is finished, clean the
cappuccino accessory and the steam nozzle
with a damp cloth.
. HEATING OTHER LIQUIDS
• Take out the steam nozzle.
• Remove the cappuccino accessory.
• Make sure the boiler is full of water.
• Set the pump switch to position
.
• Switch on the appliance.
A little water and steam will escape from the
percolation head while the appliance is
heating up.
• When the yellow temperature indicator light
goes out, place a container under the steam
nozzle and turn the steam tap to max
position.
• Let the water flow until steam appears, then
turn the tap back to position O.
• Place the container under the steam nozzle
in such a way that the jet is immersed in the
liquid.
• Turn the tap slowly to max position.
• Once the liquid is hot enough, reset the tap
to position O and remove the container
from the nozzle.
Note :
If you wish to prepare an espresso
immediately after using steam, it is vital that
you allow the appliance to cool down to the
«coffee making» temperature :
• Place a container under the filter holder and
set the pump switch to the « » position.
• Let the water run through until the yellow
temperature indicator light goes out.
• Reset the pump switch to position
, after
which you may prepare an espresso in the
usual way.
Cleaning
• Before doing any cleaning, unplug the
appliance and allow it to cool down.
• Wipe the body of the appliance with a
damp cloth.
The water tank must be emptied after use.
• Remove the cup rest grid and clean it (20).
• Empty the drip tray and clean it.
ART. 880.PM6.5 19/01/04, 16:0118