Filter
Top Products
6. Communication Function
6.2.2 Setting sequence of
high speed link
Project
Select standard screen of
project
↓
High speed link parameter
High speed link 1 ~ 4
↓
High speed link setting(link setting)
Link-enable
Self station number(0~63)
Slot number(0~7)
Unit type
•
MASTER-K Fnet
↓
High speed link setting
(registration list)
Station number(0~63)
Block number(0~63)
Unit type
•
Local Out
•
Local In
•
Remote Out
•
Remote In
Transmission range/ Receive
range
Size(1~60 word)
Tx/Rx period(200ms~10sec)
↓
Online(After local connection)
Download
•
Parameter
•
Parameter and program
↓
Mode switch
Switch operation mode to RUN
mode
Select standard screen of project in KGL-WIN screen
Select
(4
can be set in K1000S,
2 in K300S, and 1 in K200S)
Input network type, slot number that communication module
is mounted, and self station number with decimal
In case of local connection, select self-station number for
transmission and select other station number for receive
In case of remote connection, select other station number
regardless of Tx/Rx.
Each of Tx/Rx can select 32 block number, contents of Tx/Rx
data can be distinct and selected by mutual block number in
local connection.
Only one of Tx/Rx should be selected in case of local
connection, and all of Tx/Rx can be selected in remote
connection.
Select program or program and parameter, and download to
CPU.
Other station should be set
~
(These setting is
unnecessary if other station is remote station).
Program using emergency flag, etc. should be prepared for
communication cut-off, error occurrence of other station, and
instant power failure of remote module.