LG Electronics LDF9810WW Refrigerator User Manual


 
OO
PPEERRAATTIINNGG SSEEQQUUEENNCCEE
20
6. Close the door. The dishwasher
starts automatically after a
slight delay.
7. At the end of the Program.
End is displayed on the digital display for a
few seconds and a tone will sound, signaling
program completion. The dishwasher
automatically switches off for safety and
energy savings.
CAUTION
Empty the lower rack first and then the upper
one, this will avoid water dripping from the
upper rack onto the dishes in the lower one.
WARNING
In general,it is not advisable to open the door
while the dishwasher is running. If the door is
opened, a safety device stops the machine.
Care should be taken when opening the door
immediately following the cycle, as steam may
escape.
OPERATING SEQUENCE
Auto-Off
When the power is turned on, if you don’t
select program or if you don’t close the door
after selecting a program, your dishwasher will
automatically turn off in 10 minutes.
1. Load the dishes.
Remove any scraps of food in advance. Pull
the lower rack out and load the dishes and
cutlery in and push it all the way back. Pull
the upper rack out and load the cups,
glasses, etc.
2. Turn on the dishwasher.
When ready to run a cycle, open the door and
press the power button. The dishwasher
defaults to the normal cycle.
3. Check rinse-aid.
The indicator lights will illuminate if the rinse
aid level is low.
NOTE
The estimated remaining time will be displayed. If the
door is opened during operation, the dishwasher stops.
Once the door is closed, the program will restart from
the point where it stopped.
4. Measure the detergent.
Add the required amount of detergent into the
dispenser. Close the detergent dispenser lid.
5. Setting the program.
Select desired program and options.
Before starting, the display window will show
the estimated running time of the selected
program. If the number of dishes fills only one
rack, you can use the Half Load option. For
example, if you load dishes only on the upper
rack, you adjust the Half Load button to the
upper rack.
Remember to load all dishes into the
selected rack.
The estimated remaining time will be
displayed.
If the door is opened during operation, the
dishwasher stops.
Once the door is closed, the program will
restart from the point where it stopped.
Dual Intensity
TM
Wash Cycle
Course Selection Press SPRAY key for 3
sec.
SPRAY selection for upper spray
(Strong/Medium/soft/off)
Press HALF LOAD
to select lower rack
SPRAY selection for
lower spray(Strong/Medium/soft/off)
Check
selection by press HALF LOAD
Another
option
Door Closed Start