Filter
Top Products
ENSURING HOT WATER CONNECTING A
CONVERTIBLE
For good eleaning and dryi_ig resuRSI_ hpt
(SELECT MODELS)
water ]s necessary. The incoming ,wa_r tera: 1. Turn on the faucet at the sink until hot water comes
perature should be 120-140°F to properly aeti. out. Turn off the lhucet.
vate the detergent and melt greasy foDd soils; '2. Pull the connector from the recess in the back of the
..... '° ' _ ' dishwasher as sho_.
If for any reason (such as laundering, showers, etc.) the
incoming water temperature is below 120°F (49°C),
select the Temp Sense option to have the dishwasher
thermostatically beat the water to proper temperature.
To cheek the incoming water temperature, turn on the
hot water faucet nearest the dishwasher and let it run
into a glass in the sink. Place a candy" thermometer in
the glass and cheek the temperature once it has stopped
rising. If the temperature is below 120°F (49°C), have a
qualified person raise the water heater thermostat set-
ting.
Before starting the dishwasher, turn on the hot water
f'ancet and let it run until the water is hot.
3. Press down on the thumb release and lift the con-
nector onto the faucet.
Release Faucet
Button Connector
4, Remove pressure from the thumb release and tug
slightly on the connector to be sure it is securely in
place.
5. Tnrn the hot water on full force.
6. Cheek that the sink drain is open so water from the
dishwasher can drain properly.
7, Pull the electrical cord from the recess. Plug it into a
properly gronnded outlet.
8. Select the proper cycle Ibr the load and start the
dishwasher.
ei; be s_ to tUrn the water supply off and press
the prcsgure release button BEFORE removing
Page 6