Filter
Top Products
29
Connection to drainage
NB!
The hose must be fastened level with the
underside of the work surface.
Details may differ depending on the model and the market!
Max 950 mm
Min 350 mm
Max 950 mm
Min 350 mm
Max 3 m
Max 950 mm
Min 350 mm
Connection to water supply
There must be a shut-off tap on the water
supply pipe. The shut-off tap should be
positioned above the work surface or at the
front of the sink unit.
The water supply pipe has a connection
with a 1/2” or 3/4” internal thread depending
on country.
When the installation is complete, the shut-
off tap should be opened to allow the pres-
sure to settle for a while and to check that
all connections are tight.
Connection to electricity
A dishwasher fitted with a lead and plug
must be connected to an earthed socket.
Repairs and maintenance affecting safety or
performance must be carried out by a quali-
fied professional.
Technical data
See the type plate on the right hand side of
the door.
CAUTION!
The lead must be disconnected or the socket
voltage-free while the work is carried out!
Connection to drainage
When the drain hose is routed to a
connection nipple at the sink’s water trap
(see illustration 1), note that the hose must
be fastened level with the underside of the
sink unit – otherwise the dishwater from the
sink can run down into the dishwasher. The
drain hose is threaded onto a cone-shaped
connecting pipe at the sink unit’s water trap.
The cone-shaped pipe must be cut to an
internal diameter of at least 16 mm. For
other alternative connections, see
illustrations 2 and 3.
The drain hose may be lengthened by a
maximum of 3 m (the total length of the
drain hose may not exceed 4.5 m). Any
connections and connecting pipes must
have an internal diameter of at least 16 mm.
However, the drain hose should ideally be
replaced with a new hose without joins.
No part of the drain hose may be more than
950 mm above the bottom of the machine.
The hose must not be routed directly to the
floor drain or similar. In such cases, the
hose can act as a siphon and empty the
dishwasher.
The hose must always discharge at least
350 mm above the bottom of the machine.
Illustration 1
Illustration 2
Illustration 3