Maytag 8113P448-60 Range User Manual


 
26
Troubleshooting
Oven did not self-clean properly Longer cleaning time may be needed.
(select models). Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
Oven door will not unlock Oven interior is still hot. Allow about one hour for the oven to cool after the
after self-clean cycle completion of a self-clean cycle. The door can be opened when “LOCK” is not
(select models) displayed.
The control and door may be locked. See pages 11 and 20 to unlock.
Moisture collects on oven This is normal when cooking foods high in moisture.
window or steam comes from Excessive moisture was used when cleaning the window.
oven vent.
There is a strong odor or light This is normal for a new range and will disappear after a few uses. Initiating a clean
smoke when oven is turned on. cycle will “burn off” the odors more quickly.
Turning on a ventilation fan will help remove the smoke and/or odor.
Excessive food soils on the oven bottom. Use a self-clean cycle.
Fault Codes BAKE or LOCK may flash rapidly in the display to alert you if there is an error
(select models) or a problem. If BAKE or LOCK appear in the display, press the Cancel pad.
If BAKE or LOCK continue to flash, disconnect power to the appliance.
Wait a few minutes, and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized servicer.
If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
Noises may be heard. The oven makes several low level noises. You may hear the oven relays as they go on
and off. This is normal.
As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
There are no beeps and Control may be in Sabbath Mode. See page 15.
no display.
PROBLEM SOLUTION