Filter
Top Products
15 16022783 Rev. 0 ©2004 Maytag Appliances Company
Filters
Check for blockage of Strainer, Over Pressure Filter.
Repair as necessary.
Poor Washability
Spray Arms
Check all Spray Arms for blockage of water ports or
cracks. Check for proper rack loading to avoid interference
with Spray Arms during wash action. Check for proper
sealing, fastening, and movement of Spray Arms. Repair
as necessary.
Filters
Check for blockage of Strainer, Primary Filter, and Filter
Support. Repair as necessary.
Detergent Cup Cover
Check spring hinge operation of Detergent Cup Cover.
Repair as necessary.
Detergent Cup
Check operation of Detergent Cup Assembly, Wax Motor,
Actuator, Linkage, and Cover Latch. Repair and/or replace
parts as necessary. Note: For testing of Wax Motor, see
Section 2.
Rinse Dispenser
Check level of rinse aid in reservoir. Check rinse aid
dispenser setting.
Will Not Drain
Inadequate Drainage
Check Drain Pump for proper operation. Check the drain
pipe connections and repair as needed. If draining into the
garbage disposal, check for unprocessed food waste at
drain hose connection to disposer. Clean out as needed.
Drain Hose
Check drain hose for kink or restrictions. Reroute or
remove any restriction of drain hose as needed.
Pump Assembly
Check pump assembly for obstructions or restricted
parts. Repair or replace parts as necessary.
Wiring/Electrical Connections
Check for loose or frayed wire terminal connections.
Check for broken wire within harness. Repair or replace
as necessary.
Electrical-Mechanical Troubleshooting
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Continues To Drain
Control Board
Check Control Board for proper operation.
Wash Delivery System
Check manifold and Docking Station for good seal and no
leaks.
Poor Drying
Water Temperature
Check for low water temperature. Temperature should be
between 120 - 150 degrees Fahrenheit. If not, advise
consumer to adjust water heater setting. Encourage
consumer to purge water lines to the dishwasher area
prior to starting the dishwasher.
Cycle Options
Advise consumer use of options available on dishwasher
that improve drying. Options that improve drying are
Heated Dry, and 160° Wash.
Detergent
Check water hardness. Instruct consumer on detergent
usage, one teaspoon of detergent per grain of water
hardness.
Rinse Dispenser
Check level of rinse aid in reservoir. Check dispenser
setting under cap. Use "MAX" for hard water conditions.
Improper Rack Loading
Check how the consumer loads the dishes into the racks.
Improper loading of some types of dishes can trap water
which causes dishes not to dry.
Heating Element
Check load readings listed on Technical Sheet located
behind Toe Panel.