Filter
Top Products
Check that the lower edge of the lower panel contacts
the floor. Adjust if necessary.
3
Check lower panel edge
Hold the two panels together and place them against
dishwasher leg. Using a Phillips or 1/4" screwdriver, reinstall
the screws through the holes in the access panel and the
slots in the lower panel.
2
Reinstall access panels
Tighten access panel screws.
4
Tighten screws
20
Check that grounding clip is attached to the lower panel.
Position the lower panel behind the access panel. On some
models there is insulation on the access panel which must
fall behind the insulation on the lower panel.
1
Reinstall access panels
Gr
Gr
ounding
ounding
clip
clip
Grounding
clip
Insulation
Insulation
(on some models)
Lower
panel
Access
panel
Complete Installation
Remove towel from dishwasher. Reinstall the lower dish
rack.
Remove towel and replace
lower dishwasher rack
7
If needed, see website for animated representation
of this step. Visit www.maytag.com/anchoring under
FAQ tab.