Filter
Top Products
LOCK FUNCTION FOR CHILDREN
1. Lock: in waiting state, press "10 min. "and "10 Sec. "buttons
together, a long "beep" denotes to enter into the children-
lock state and a key is lighted. LED displays a rectangle
2. Lock quitting: in locked state, press "10 min. " and "10 sec. "
buttons together, a long "deep" denotes that lock is
cancelled, Key indicator goes out.
STATE INQUIRING
Microwave power inquiring:
In the process of microwave cooking, press "MICRO" button, it
can display the current microwave power. After three seconds, it
will turn back to the former state.
Hot-air convection temperature inquiring:
In the process of hot-air convection cooking, press
"CONVECTION" button, the display will show the current
temperature. After three seconds, it will turn back to the former
state.
Combination cooking inquiring:
In the process of combination cooking, press "MICRO/CONV"
button, the display will show the current combination type. After
three seconds, it will turn back to the former state.
FAST COOKING
Press the "QUICK COOK " button one time, add one minute to
cook instantly. (if the oven is under initial condition, the
microwave power is 100%.)
TROUBLE SHOOTING
- Check to ensure that the oven is plugged in securely. If not,
please remove the plug from the outlet and plug it in again.
- Check for a blown circuit fuse or a tripped main circuit
breaker. If these seem to operating properly, try the outlet
with another appliance.
- Check to see if the control panel is programmed correctly
and that the timer is set.
- Check to make sure that the door is securely closed,
engaging the door safety lock system.
- Check that the childproof lock is turned off. If not, turn it off
by pushing the numeral pads 10 min & 1 sec at the same
time. See child proof lock section above.
CLEANING
- Turn the oven off and remove the power plug from the wall
socket before cleaning.
- Keep the inside if the oven clean. When food splatters or
spilled liquids adhere to the oven walls, wipe with a damp
cloth. Mild detergent may be used if the oven gets very dirty.
The use of harsh detergent or abrasives is not
recommended.
- The outside oven surface should be cleaned with a damp
cloth. To prevent damage to the operating parts inside the
oven, water should not be allowed to seep into the
ventilation openings.
- Do not allow the control panel to become wet. Clean with a
soft damp cloth. Do not use detergents, abrasives or spray
on cleaners on the control panel. When cleaning the control
panel, leave oven door open to prevent oven from
accidentally turning on.
- If steam accumulates inside or around the outside of the
oven door, wipe with a soft cloth. This may occur when the
microwave oven is operated under high humidity conditions
and in no way indicates malfunctions of the unit.
- It is occasionally necessary to remove the glass tray for
cleaning. Wash the tray in warm sudsy water or in a
dishwasher.
- The roller ring and oven cavity floor should be cleaned
regularly to avoid excessive noise. Simply wipe the bottom
surface of the oven with a mild detergent, water or window
cleaner and then dry. The roller ring may be washed in mild
sudsy water or dishwasher. Cooking vapours collect during
repeated use but in no way affect the bottom surface or
roller ring wheels. When removing the roller ring from cavity
floor for cleaning, be sure to replace in the proper position.
- When it becomes necessary to replace the oven light, please
consult a dealer to have it replaced.
ENVIRONMENTAL TIP
An electronic appliance should, when it is no longer capable of
functioning be disposed of with least possible environmental
damage according to the local regulations in your municipality. In
most cases you can discharge the appliance at your local
recycling center.
Please store the original packaging for returning to repair or other
kind of transportation or storrage.
THE WARRENTY DO NOT COVER
- If the above points have not been observed.
- If the appliance has not been properly maintained.
- If force has been used against it or if it has been damaged in
any other way.
- Errors or faults owing to defects in the distribution system.
- If the appliance has been repaired or modified or changed in
any way or by any person not properly authorised.
Owing to our constant development of our products on both
functionality and design we reserve the right to change the
product without preceding notice.
IMPORTER
Adexi A/S
Adexi AB
We take reservations for printing errors.
20
Failure
Display
Handling
Temp. sensor is open. Program
temporary shut down
E1
The fan in the oven START to
cool down the cavity. Oven
restart when the right temp has
Temp.sensor has short-circuit.
Program temporary shut down
E2
The fan in the oven START to cool
down the cavity. Oven restart when
the right temp has been reached.
Wanted temp not reach within 30
min. during preheat of Convection
E3
If failure continues contact
authorized personnel for repair.
ED8525SF_IMnew6B 30/01/04 8:21 Side 20