Melitta ME1MSB Coffeemaker User Manual


 
Quick Start: Plug & Play
MSN
®
Direct constantly streams both time and region-specific weather
information to more than 120 cities in North America.
NO set-up, NO subscription, NO internet connection is
necessary to receive the most up-to-the-minute time and weather
information. All data is updated constantly, 24/7 via a regional
FM signal.
1. Carefully unpack your Coffee Maker. Remove any labels from the
outside surfaces.
2. Plug the Smart Mill & Brew™ Coffee Maker into a 120V AC
electrical outlet.
3.
The “Welcome” screen will appear, followed by “Scanning for Signal.”
Depending on the signal strength in your area, “Acquiring Signal”
may remain on the LCD Display for up to 1 hour. Please be patient.
4. While the unit is scanning for the signal, you may begin to
brew a Carafe of freshly ground coffee. Simply press the
COFFEE/WEATHER Button and the “Mill & Brew Idle”
screen will appear.
HELPFUL HINT: Use the COFFEE/WEATHER Button to
toggle between Coffee Mode and Weather Mode.
5. If this is the initial use of the Coffee Maker, please consult the section
entitled “Before Using Your Smart Mill & Brew™ For The First Time”
and follow the steps outlined on pages 14 and 15 to make sure the
unit is properly cleaned and ready for brewing.
6. After cleaning, simply add your favorite whole bean coffee and water,
select the grind setting for coffee beans, then grind and brew fresh
coffee immediately. Ground coffee may also be used. Please consult
the “Brewing Coffee: Immediate Start” section described on pages
15 to 17 for detailed procedures.
Quick Start
User
Maintenance
24
7. Press the ON/OFF Button to turn the Coffee Maker ON again.
Allow the vinegar/water solution to cycle through the Coffee
Maker. When the brew cycle is finished, press the ON/OFF
Button to turn the Coffee Maker OFF and discard the
vinegar/water solution.
8. To rinse: Allow the Coffee Maker to cool for 15 minutes. Fill the
Carafe with cold fresh water. Pour the water into the Water
Reservoir. Replace the Carafe onto the Warming Plate and press
the ON/OFF Button. When the brew cycle is complete discard
the water. Repeat with another Carafe of fresh water. Discard the
rinse water.
9. Wash and dry all removable parts. Wipe the exterior of the
Coffee Maker with a damp cloth.
5
᭤᭤
WARNING: Changes or modifications to this equipment
not expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is needed.
• Consult the dealer or an experienced radio/TV technician
for help.
Melitta_ME1MSB_IB_7-12-06 12/7/06 2:44 PM Page 13