Filter
Top Products
Cutting out the countertop
All Miele combisets have the same
length and width. Make sure that there
is enough room beneath the countertop
to allow for the depth of the various
appliances. When installing a KM 402 /
KM 403 or KM 410 / KM 411 remember
to allow clearance for the drain valve
that will be located in the cabinet
beneath the appliances.
The following safety distances must be
maintained:
–
Between the cooktop and rear wall:
2" (50 mm).
–
Between the cooktop and side wall
or cabinet:
KM 400 = 2" (50 mm)
KM 402 / 403= 2" (50 mm)
KM 408-1 = 2" (50 mm)
KM 410 / 411 =10" (250 mm)
Refer to section "Important Safety
Instructions" for further information.
Installing one or multiple appliances:
Cut out the countertop using the
dimensions listed in the following table.
Number of
cooktops
Cut out width
Dimension "B"
1 10
13
/
16
" (274 mm)
2 22
1
/
8
" (562 mm)
3 33
7
/
16
" (850 mm)
4 44
13
/
16
(1138 mm)
5 56
1
/
8
" (1426 mm)
6 67
1
/
2
" (1714 mm)
7 78
13
/
16
" (2002 mm)
The tolerance for each dimension is
1
/
16
" (1 mm).
When installing more than one
combiset cooktop, a support bar
must be installed between the
appliances. Install the support bars
as shown on the following page
before setting the appliances into
the countertop.
Installation
9