Filter
Top Products
97
Parameter list
Parameter list
5
ADJUSTMENT
Frequency setting by analog input — Noise elimination at the analog input (Pr.74)
74
Input filter time
constant
1 1 0 to 8
The primary delay filter time constant for the
analog input can be set.
A larger setting results in slower response.
Misoperation prevention and parameter setting restriction — Reset selection and discon-
nected PU detection (Pr.75)
75
Reset selection/
disconnected PU
detection/PU stop
selection
114
0 to 3,
14 to 17
You can select the reset input acceptance,
disconnected PU (FR-DU07
/FR-PU04/FR-
PU07
) connector detection function and PU
stop function.
For the initial value, reset always enabled,
without disconnected PU detection, and with
PU stop function are set.
××
Operation setting at fault occurrence — Output function of fault code (Pr.76)
76
Fault code output
selection
10
0 Without fault code output
1 With fault code output
2 Fault code output at fault occurrence only
Misoperation prevention and parameter setting restriction — Prevention of parameter
rewrite (Pr.77)
77
Parameter write
selection
10
0 Write is enabled only during a stop
1 Parameter write is disabled.
2
Parameter write is enabled in any operation
mode regardless of operating status.
Misoperation prevention and parameter setting restriction — Reverse motor rotation pre-
vention (Pr.78)
78
Reverse rotation
prevention selection
10
0 Both forward and reverse rotations allowed
1 Reverse rotation disallowed
2 Forward rotation disallowed
Selection of operation mode and command source — Operation mode selection (Pr.79)
Selection of operation mode and command source — Operation mode at power-ON (Pr.79,
Pr.340)
79
Operation mode
selection
10
0 External/PU switchover mode
1 Fixed to PU operation mode
2 Fixed to External operation mode
3 External/PU combined operation mode 1
4 External/PU combined operation mode 2
6 Switchover mode
7
External operation mode (PU operation
interlock)
340
Communication
startup mode
selection
10
0As set in Pr.79.
1, 2
Started in the network operation mode.
When the setting is "2", it will resume the pre-
instantaneous power failure operation mode after an
instantaneous power failure occurs.
10, 12
Started in the Network operation mode.
Operation mode can be changed between the
PU operation mode and Network operation
mode from the operation panel.
When the setting is "12", it will resume the pre-
instantaneous power failure operation mode after an
instantaneous power failure occurs.
Parameter
Name
Incre-
ments
Initial
Value
Range Description
Parameter
copy
Parameter
clear
All parameter
clear
Related
parameters
: enabled
× : disabled