Filter
Top Products
3
SAFETY INSTRUCTIONS
1. Electric Shock Prevention
WARNING
While power is on or when the inverter is running, do not open the front cover. You may get an electric shock.
Do not run the inverter with the front cover removed. Otherwise, you may access the exposed high-voltage
terminals and charging part and get an electric shock.
If power is off, do not remove the front cover except for wiring or periodic inspection. You may access the
charged inverter circuits and get an electric shock.
Before starting wiring or inspection, switch power off, wait for more than 10 minutes, and check for no residual
voltage with a tester or the like.
Any person who is involved in the wiring or inspection of this equipment should be fully competent to do the
work.
Always install the option unit before wiring. Otherwise, you may get an electric shock or be injured.
Operate the switches with dry hands to prevent an electric shock.
Do not subject the cables to scratches, excessive stress, heavy loads or pinching. Otherwise, you may get an
electric shock.
2. Injury Prevention
CAUTION
Apply only the voltage specified in the instruction manual to each terminal to prevent damage, etc.
Ensure that the cables are connected to the correct terminals.
Otherwise, damage, etc. may occur.
Always make sure that polarity is correct to prevent damage, etc.
While power is on or for some time after power-off, do not touch the inverter as it is hot and you may get burnt.