Morphy Richards 43541 Water Dispenser User Manual


  Open as PDF
of 6
 
• Change display G:
Every week, one bar will
disappear to show the
remaining cartridge life. After
four weeks, all four bars will
disappear. This, and a flashing
arrow, indicate that the
cartridge should now be
changed. Insert a new
cartridge according to the
instructions, and reactivate the
Memo as described above.
REPLACING THE
BRITA MEMO
BRITA Memo - the electronic
cartridge exchange reminder
has a life of approximately 5
years. At the end of the
Memo’s life, please remember
that it is an electronic device
and to dispose of the Memo
according to all applicable
provisions and regulations. To
remove the exhausted Memo,
place a screwdriver in the notch
next to the Memo and push it
out. Please note that Memo
should not be removed for any
other reason than to dispose of
it.
More information on the use of
BRITA filter cartridges and the
BRITA Memo can be found in
the BRITA information guide
supplied with the kettle.
Telephone our replacement
parts helpline for your new
BRITA Memo.
SWITCHING ON
You do not need to wait until
the water has filtered through
before boiling. Your Morphy
Richards filter kettle will boil
and filter at the same time,
giving you boiled BRITA filtered
water quickly.
• Boil only as much water as you
need, as this saves electricity.
1 Place the filter kettle on the
base unit, ensuring the kettle
locates on to the 360°
connector.
• The 360° connector allows the
kettle to be located at any
position - ideal for left and right
handed users and convenient
positioning on a worktop.
2 Plug in and switch on at the
wall socket.
3 Switch the kettle on. The kettle
will illuminate internally.
4 When the water boils, the filter
kettle will switch off
automatically.
• If you are using the kettle for
the first time, discard the water
and repeat once more.
• To re-boil, switch to ON again.
If the kettle has just switched
off, wait a minute or so before
switching it back on again.
• If you do not put in enough
water, or switch on the filter
kettle when it is empty, the
safety cut-out will switch off the
power automatically. If this
happens, refill and wait a few
minutes for the element to cool,
then use as normal.
5 Lift the filter kettle from the
base unit by the handle,
ensuring you hold the kettle
level.
WARNING: Unless the
cartridge holder is fitted
correctly, the filter kettle
may not operate correctly
and the lid may not close
and lock securely.
WHEN TO
CHANGE
YOUR BRITA
MAXTRA
CARTRIDGE
This depends on water quality
and the improvement required.
We recommend that you
change your cartridge after 4
weeks.
The electronic reminder on your
Morphy Richards water filter
kettle will remind you when to
change your cartridge.
BRITA filter cartridges conform
to the highest quality
standards. Raw materials and
final products are subject to
stringent internal and external
controls. BRITA filter cartridges
are steam sterilised. An
independent institute certifies
the food grade quality of BRITA
water filters and cartridges.
Great taste, less waste:
The BRITA MAXTRA cartridge
is 100% recyclable. Please
contact BRITA customer care
team for advice on recycling
schemes on
0844 742 4800, or visit
www.brita.co.uk/recycle H.
HINTS AND TIPS
Cleaning and
maintenance
WARNING: Always
disconnect the plug from
the mains and allow the
appliance to cool before
cleaning.
Wipe the outside with a damp
cloth.
IMPORTANT: Do not use
abrasive cleaners on the
outside of the appliance,
as they may scratch the
surface.
55
UUKK HHeellpplliinnee 00884444 887711 00995544 RReeppllaacceemmeenntt PPaarrttss 00884444 887733 00772200 IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
H
G
43541 Rev1 29/4/08 16:27 Page 1
next