Filter
Top Products
－19－
7-2, SEMI ELECTRONIC MODE
A. Temperature control part design
B. Temperature control function
1) Tempera ture choice of freezer
·You can choose to ⑧ From ①
·Follows are control temperature by KNOB position.
Freezer temperature control refrigerator temperature control
KNOB position
control temperature
①
-16.0
②
-17.0
③
-18.0
④
-19.0
⑤
-20.0
⑥
-21.0
⑦
-22.0
⑧
-23.0
2) Temperature choice of refrigerator
·You can choose to ⑧ From ①
·Follows are control temperature by KNOB position.
NOTE) Temperature contol of freezer and refrigerator is position control by ROTRAY S/W, if it get out of
position it control NOTCH
C. Defrost function
1) Defrost set up by time of COMP ON.
2) Defrost tun Heating → Rest time
3) When initial power on, initial defrost run defrost of freezer and refriger ator in 4 hours of COMP
ON. Since initial
(R →R, F →R →R, F ... Cycle operating))
4) ON/OFF of defrost - heater control by EVA-SENSOR If EVA-SENSOR is problem (short 10 pen),
it run just rest time and then finishes defrost function without heating.
5) During defrosting it maintain COMP and FAN state and after finish defrost-heating rest time
is 10 minutes.
6) Follows are defrost heating ON point and OFF point that operate by EVA-SENSOR.
KNOB position
control temperature
①
5.0
②
4.0
③
3.0
④
2.0
⑤
1.0
⑥
0
⑦
-1.0
⑧
-1.0
HEATER ON dot
HEATER OFF dot
REFRIGERATOR
BEIOW+10℃
FREEZER
BEIOW -5℃
REMARK
17℃
TEMP, FRE
TEMP, REF