Sears 139.53759 Garage Door Opener User Manual


 
Model 139.53779
3-Function Remote Control
Owner's Manual
Model 139.53759
3-Function Compact Remote Control
To comply with FCC rules, adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing
the code setting or replacing the battery. THERE ARE NO
OTHER USER SERVICEABLE PARTS.
The 53000 Series remote control (with green
battery test light) works only with door
openers and light controls having a green
"SRT" button and green indicator light.
Instructions are given below for programming
your opener to match the remote control's
code. The additional remote control buttons
can also activate other garage door openers
and/or light controls. (Instructions for
programming light products are included with
those accessories.)
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the wall push button(s) or remote
control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
53000 Series Garage Door Openers
(With Green "SRT" Button and Green Indicator Light)
PROGRAM THE OPENER TO ACCEPT
THE REMOTE CONTROL CODE
Select a remote control push button to operate the
receiver. The large button is recommended for use
with the garage door opener.
1. Press and HOLD the selected remote control
push button, Figure 1.
2. Then press and release the green "SRT" button
on the right side panel of the opener in Figure 2.
The opener light will flash once.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener light flashes, the opener has
not accepted the code.
To Change the Selected Push Button
On the Same Remote Control
If you decide to use a different remote control button
than originally programmed into the opener, you
need to erase a//the learned codes and reprogram
each remote control used to operate the garage
door opener.
To Erase All Remote Control Codes
Press and hold the green "SRT" button on the
opener panel until the indicator light turns off
(about 6 seconds). AIIthe codes the opener has
learned will be erased.
• To reprogram, repeat Steps 1,2 and 3 for each
remote control in use.
Figure 1
Model 53759
/
Select a remote controt push
button to operate opener
Model 53779
Figure 2
Garage Door Opener
(With Green "SRT" Button)
Green indicator
"SRT" Light
Button
Code programming instructions are also located on
the opener panel.
Replacement Parts:
12 Volt battery- 10A14; Compact remote control case, cover and Velcro strip (circuit board not included) -41A3592;
3-Function remote control case, cover, screw (circuit board not included) - 41A3888; Visor Clip - 29C128
© 1994, Sears Roebuck & Company
114A1462D All Rights Reserved Printed in Mexico