LIFT-UP COOKTOP
The range has s support to hold the cooktop up while
cleaning.
Raise the support as shown In the Illustration.
Porcelain enamel can chip if dropped. Handle
porcelain enameled €ooktops carefully.
ANTI-TIP DEVICE
If your range is removed for cleaning,
servicing or any reasonj be sure anti-
tip device is re-engaged properly
when the range is replaced. Failure
to take this precaution could result in
tipping of the range and cause injury.
NOTE: To Insure the device Is Installed and re-en-
gaged properly, carefully try to tip the range
forward. The device should secure the range
and not allow It to tip.
BACKGUARD
When replacing the range:
1. Hook the loose end of the chain onto the bracket by
slipping the nearest link of the chain Into the slot In
the bracket, making sure the chain Is pulled as tight
as possible and that there Is no excess slack In the
chain after chain Is attached to the bracket.
• Excess slack In the chain could allow the range to
tip over.
2. Slide the range all the way back Into the counter.
Oncethe range Is pushed back In place, there will be
a small amount of slack In the chain. This Is normal.
OPTIONAL
LOCATION
FACTOR_
LOCATION MAINBACK
(Electric model shown;
Opposite side used for Gas models)
18 NEMNT59