Filter
Top Products
18
Ventura Deluxe Storage Procedure
1. Perform a fresh water flush as described in the normal operation section. Shut down the
feed pump but leave the valves in the flush position.
2. Remove the quick disconnect fitting from the brine discharge outlet of the Clark Pump and
replace with a quick disconnect service hose from your service kit. Lead the hose to a 5 gal-
lon bucket or container.
3. Start and run the feed pump until you have one gallon of fresh water in the bucket.
4. Mix 1 container of SC-1 storage compound with the water in the bucket.
5. Connect the service hose, using the garden hose barb fitting from your service kit, to the
service port of the fresh water flush module. Lead the hose into the bucket. Turn the service
valve on the fresh water flush module 180°, so the intake is now coming from the bucket.
6. Make sure the pressure relief valve on the
Clark Pump is OPEN (unpressurized)
by turning
1
/
2
turn counterclockwise
7. Turn on the feed pump. Circulate the storage
chemical in the system for approximately 10
minutes. Turn off the feed pump when fin-
ished.
Clean Up
Remove the quick disconnect from the Clark Pump brine discharge, and replace the original
hose that leads to the thru-hull. You may at this point, if you choose to, pump the bucket dry
by using the feed pump switch. Stop when the bucket is empty.
Turn the service valve 180° back to its original position, and remove the service hose.
Close the seacock and drain and clean the strainer and any filters in the system. Reassemble
dry.