Sub-Zero Freezer Freezer User Manual


 
17
Dimensions in parentheses are in
millimeters unless otherwise specified.
MODELS 685 AND 695 GLASSWELL
The dispenser area of Models 685 and 695 has
been engineered to enable the use of the
o
verlay panel application. Installing overlay
panels for these models is the same procedure
as for other Built-In models. The refrigerator
d
oor panel will need to accommodate a cut-out
for the glasswell bezel.
To remove the glasswell bezel for an overlay
Model 685 or 695, the water grille and touch
pad must be removed. Lift the water grille up
and out. Next, remove the touch pad assembly
which is taped in place, by removing the
center plastic mandrel supports. Carefully tilt
the touch pad out and disconnect the wire
harness (blue side up) from the back side of
the touch pad. Remove the bezel by removing
the four screws.
Insert the overlay panel into the door trim.
Reverse the procedure to install the bezel,
touch pad and water grille. To install the plastic
rivets, insert rivets through the touch pad and
into the control housing and secure by
pressing mandrels into the body of the rivets.
Refer to illustrations 14 and 15 below.
IMPORTANT NOTE:
The total panel thickness
(including backer and spacer, if used) in the
glasswell bezel area can range from
1
/4" (6) to a
maximum of 1
1
/8" (29). If the panel is thicker,
provisions must be made to rout out a space
to accommodate the bezel surrounding the
glasswell.
OVERLAY GRILLE PANELS
Models 611, 611G, 650, 650G, 661, 642, 685,
632 and 695:
Remove the inner grille panel
a
ssembly as described in Grille Removal,
page 9. Remove the top two corner screws and
pull away the top frame. Slide the panel into
p
osition in the grille frame. If you are using a
grille panel
1
/4" (6) or thinner, you will need to
install a filler.
Reattach the top frame by reinstalling the
two top corner screws. Install the inner grille
panel assembly onto the unit, by reversing the
procedure outlined in Grille Removal, page 9.
Refer to specifications for Overlay Grille Panels
on page 19, and illustration 13 on page 16, for
the exact sizing of all three panels.
Water
Grille
Water
Key Pad
Light
Key Pad
Ice
Key Pad
Touch Pad
Lock
Indicator
Glasswell
Bezel
Illus. 14
Illus. 15
Do not exceed the panel dimensions
listed for the appropriate overlay grille
panel you are specifying. The overlay
decorative panel cannot be any larger or
it may restrict the air flow to the
compressor area and cause problems with
the operation of the Sub-Zero unit.
OVERLAY PANEL INSTALLATION
PANEL
DESIGN
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.