Filter
Top Products
1
Models 750, 751, 754, 774, 791, 794 To the Installer
081208
Section 1 To the Installer
The following are general installation instructions. For
complete installation details, please see the checkout
card.
Installer Safety
In all areas of the w orld, equipment should be
installed in accordance with existing local codes.
Please contact your local authorities if you have any
questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing activities related to the installation and
service of Taylor equipment.
S Only authorized Taylor service personnel
should perform installation and repairs on the
equipment.
S Authorized service personnel should consult
OSHA Standard 29CFRI910.147 or the
applicable code of the local area for the
industry standards on loc kout/tagout
procedures before beginning any installation
or repairs.
S Authorized service personnel must ensure
that the p roper PPE is available and worn
when required during installation and service.
S Authorized s ervice personnel must remove all
metal jewelry, rings, and watches before
working on electrical equipment.
The main power supply(ies) to the freezer
must be disconnected prior to performing any repairs.
Failure to follow this instruction may result in personal
injury or death from electrical shock or hazardous
moving parts as well as poor performance or damage
to the equipment.
Note:Allrepairsmustbeperformedbyan
authorized Taylor Service Technician.
This unit has m any sharp edges that can
cause severe injuries.
Site Preparation
Review the area the unit is to be installed in before
uncrating the unit making sure that all possible
hazards the user or equipment may come into have
been addressed.
Air Coo led Units
DO NOT obstruct air intake and discharge openings:
Counter Model: 6” (152 mm) minimum air space on
both sides and 0” on the rear.
Console Models: 3” (76 mm) minimum air space on
all sides.
This will allow for adequate air flow across the
condenser(s). Failure to allow adequat e clearance can
reduce the refrigeration capacity of the freezer and
possibly cause permanent damage to the compressor.
For Indoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of
70_-75_F(21_-24_C). The freezer has successfully
performed in high a mbient temperatures of
104_(40_C) at reduced capacities.
This unit must NOT be ins talled i n a n area
where a water jet or hose can be used. NEVER use a
water jet or hose to rinse or clean the unit. Failure to
follow this instruction may result in electrocution.
This unit must be installed on a level surface
to avoid the hazard of tipping. Extreme care should be
taken in moving this equipment for any reason. Two or
more persons are required to safely move this unit.
Failure to comply may result in personal injury or
equipment damage.
Uncrate the unit and inspect it for damage. Report any
damage to your Taylor Distributor.
This piece of equipment is made in the USA and has
USA sizes of hardware. All metric conversions are
approximate and vary in size.