Filter
Top Products
20
Models 8751/8754Operating Procedures
Insert the assembled mix inlet tube into the hole in the
base of the liquid valve body.
Figure 27
Secure the pump parts in position by sliding the
retaining pin through the cross holes located at the
bottom o f the pump c ylinder.
Figure 28
Note: When the pump is correctly installed, the head
of the retaining pin should b e facing up.
Step 7
Install one o-ring on each end of the mix feed tube.
Thoroughly lubricate.
Figure 29
Step 8
Slide the large o-ring and two small o-rings into the
grooves on the drive shaft. Thoroughly lubricate the
o-rings, and the shaft. DO NOT lubricate t he hex end
of the shaft.
Figure 30