Filter
Top Products
HT10 Heated Throw User Manual HT10 Heated Throw User Manual HT10 Heated Throw User Manual
SAFETY GUIDE - PLEASE READ CAREFULLY
Please follow all the safety precautions listed
below for safety and to reduce the risk of re,
injury or electrical shock.
Read the following instructions carefully •
before using the heated throw and retain
the instructions for future use. If you pass
this product to a third person, please include
these instructions.
Remove any packaging material and •
promotional stickers before using the heated
throw for the rst time.
ELECTRICAL CAUTIONS
Fully unwind the power cord before use.•
Use the heated throw only with the detachable •
controller provided.
If any abnormality or defect in operation of •
this appliance is observed, discontinue its use
immediately and consult a retailer’s service
agent or similarly qualied person.
Regularly inspect the supply cords, plugs, •
controllers and throw to ensure that the
appliance is in serviceable condition. If found
damaged in any way, immediately cease use
of the throw as a safety hazard may exist.
It is recommended that a qualied and •
registered person inspect your heated throw
after each 3 years of use.
The appliance is supplied with a specially •
designed controller and no attempt should
be made to repair it.
There are no serviceable parts inside the •
product.
Use this product only on a 220-240VAC mains •
supply.
When removing the plug from the mains •
supply, hold the plug not the power cord.
The mains plug is the ultimate means of •
disconnection from the mains supply. At
all times the mains supply plug must be
unobstructed and freely operable.
The installation of a residual current device •
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit supplying the appliance.
Consult your electrician for professional
advice.
WARNING: If the power cord is damaged, it must
be replaced by the manufacturer, its service agent
or similarly qualied persons in order to avoid a
hazard.
INSTALLATION CAUTIONS
This appliance is to be used as a wrap only. It •
is not an electric blanket or over blanket. It is
not designed for all-night use.
Do not use the throw rucked, rolled or folded. •
Spread it out fully.
Keep the control unit away from open •
windows.
Do not use pins or sharp objects with this •
product – they may damage the electric
wiring.
Do not coil or lay the exible lead on the •
throw.
This appliance is for domestic use only. It is •
not intended for use in hospitals.
Do not use the appliance for anything other •
than its intended use. Do not use outdoors.
CAUTIONS IN USE
Do not pull the heated throw by the exible •
cord or use the cord to carry it. Do not attempt
to expose the internal wires.
Do not sit on, crease or crush the heated throw •
or leave heavy objects on the throw when it is
switched on.
Do not use under clothing, wraps or blankets.•
Do not fall asleep when using the heated •
throw. This product is not intended for use
while sleeping.
Do not tuck in the heated throw.•
To avoid overheating, this throw must be •
kept in the fully spread condition at all times
during use.
Switch o at the power outlet and remove the •
plug when the heated throw is not in actual
use.
It is dangerous to use a hot water bottle at the •
same time as this appliance.
Do not use the heated throw with an infant, •
an inrm person or anyone unable to detect
or regulate the temperature for themselves.
The heated throw is not to be used by young •
children, unless the controls have been pre-
set by a parent or guardian, or unless the child
has been adequately instructed on how to
operate the controls safely.
The heated throw is not to be used on or by an •
invalid, a sleeping or unconcious person, or a
person with poor blood circulation.
Use only for human use, not for pets.•
Extended application at a high setting may •
result in skin irritation or burns.
Do not use on areas of sensitive skin, or areas •
insensitive to heat.
Do not switch the power on if the heated •
throw is wet or in a folded state.
This appliance is not intended for use by •
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliances by a person
responsible for their safety.
Children should be supervised to ensure that •
they do not play with the appliance.
If the throw gets soiled, follow the cleaning •
instructions in full.
Do not switch the throw on if it is wet or after •
washing. Allow it to dry naturally.
Do not dry-clean the throw. Cleaning liquids •
may damage the insulation or covering of the
heating unit.
Avoid pressing creases into the appliance.•
When storing, allow the throw to cool fully •
before folding. Fold neatly, but not tightly (or
roll) in the original packaging without sharp
bends in the heating element and store where
no other objects will be placed upon it.
ELECTRICAL INFORMATION
Before using this appliance ensure that the
voltage of your electricity supply is the same as
that indicated on the label and the rating plate of
the controller.
SPECIFICATIONS
Model: .................................HT10 Heated throw
Voltage: .............................. 220-240 V~, 50Hz
Power consumption: ..... 110 Watts
Net Weight: .......................1.4 kg
Class II construction double insulated.
This product must not be connected to
earth.
WARRANTY
Your appliance is covered by a warranty for 12
months from the date of purchase. If a fault
develops during this period, please return the
unit to your nearest Tesco store together with the
original receipt as proof of purchase. This warranty
in no way aects your consumer rights
UK: Waste electrical products /batteries
should not be disposed of with
household waste. Separate disposal
facilities exist, for your nearest facilities.
See www.recycle-more.co.uk or in-store
for details.
ROI: Produced after 13th August 2005.
Waste electrical products/batteries
should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice.
PREPARATIONS FOR USE
Remove all exterior packaging from the appliance.
Carefully remove the heated throw from the
polythene storage bag. Retain the bag for future
use. If you dispose of any packaging please do so
according to any recycling regulations.
CONNECTING THE CONTROLLER
The controller plug connects to the socket on the
heated throw.
Connecting the controller plug
Push the plug fully home into the socket, ensuring
that the security latch has engaged on the pin at
the side of the plug.
NOTE: The plugs are polarised so will only t the
socket when correctly aligned.
CONTROLS AND FEATURES
Heat setting display1.
Heat setting button2.
Power indicator3.
OFF/ON slide switch4.
Removing a controller plug
Lift the security latch.1.
Pull out the plug.2.
HT10 V0.1
CAUTION: Always hold both the plug and socket
when connecting or disconnecting the controller.
NEVER pull on the cable or throw to disconnect
the controller plug.