Filter
Top Products
9
NOTE: The Removable Cylinder should NEVER be used in a
conventional oven, microwave oven, on top of the range or on
any other heated surface. If the Removable Cylinder is scratched
or chipped or dented do not use. Do not add hot liquids to the
Removable Cylinder.
2. ATTACHING THE TRANSPARENT COVER
Place the Transparent Cover into the bottom of the Dasher Motor
and secure with the supplied locknut. (See Figure 2)
Figure 2
Figure 3
8
BEFORE USING FOR THE FIRST TIME
Carefully unpack and remove any packing materials and literature.
Before use, thoroughly wash all parts that will come into contact
with the ice cream (including the Removable Cylinder, Dasher and
Transparent Cover) with warm soapy water, rinse, and wipe dry
with soft cloth. You may wipe the Fixed Stainless Steel Cylinder
with a damp cloth but make sure it is completely dried before use.
Never immerse Motor Housing or Dasher Motor in water or any
other liquid.
IMPORTANT: Place the Frozen Dessert Maker upright on a flat
surface for at least 12 hours before using it for the first time, to
allow the oil contained in the compressor to return to the
compressor reservoir. Failure to do so before operation could
cause permanent damage to the unit.
This procedure must be followed whenever the Frozen Dessert
Maker has been placed in a non-upright position for any reason.
When your Frozen Dessert Maker is first used, you may
experience an odor. This is normal. After the first few uses, this
should no longer occur.
PREPARING THE FROZEN DESSERT
MAKER
Before assembling the Frozen Dessert Maker, make sure the
Start/Stop Button of the Dasher Motor is in the Stop position and
the electric power cord is unplugged.
1. ADDING THE REMOVABLE CYLINDER
Insert the Removable Cylinder to the Fixed Stainless Steel
Cylinder of the Frozen Dessert Maker’s housing, until the
Removable Cylinder is completely seated into position. (See Figure 1)
3. INSERTING THE DASHER
Make sure the Start/Stop Button of the Dasher Motor is in the
Stop Position. When the button is depressed it is in the Start
Position and when it is not it is in the Stop Position. Insert the
Dasher into the Dasher Motor Socket, until the Dasher snaps
into position. (See Figure 3)
WARNING: To reduce the risk of personal injury, always unplug
Frozen Treat Maker’s Dasher Motor before inserting or removing
Dasher.
NOTE: It is important that the Dasher be inserted properly into
the Dasher Motor Socket. Installing the Dasher any other way
will result in an incorrect mixing action.
NOTE: Do not use any Dasher other than the one provided
(P/N 71131).
Figure 1