Filter
Top Products
Juicer Part Description
Parts are listed according to this photo from the top down.
1. Cover
2. Ream
3. Screen
4. Juice Collector
5. Spout
6. Motor Base
Preparing the CitriStar for Use
Always clean the Ream, Screen, Juice Collector, and Spout before using the
appliance for the first time.
6
CitriStar Assembly and Operation
fig.1 fig.2 fig.3 fig.4
fig.5 fig.6 fig7
1. Place the appliance on a firm and level surface out of reach of children.
2. Put the Juice Collector in place correctly. (fig. 1)
3. Put on the Screen. (fig. 2)
4. Insert the Ream. (fig. 3) Plug in.
5. Switch the appliance on by pressing the halved fruit firmly onto the ream.
The juice will be extracted quietly and quickly. (fig. 4) CAUTION:
Recommend 15 seconds of operation followed by 15 seconds rest. Do not
operate more than 5 minutes at one time and allow a few minutes rest before
next use.
6. Put a container under the spout. Flip the spout down towards the container.
The instant flow system guides juice directly into the vessel. (fig. 5) After
you have finished, flip the spout up to prevent dripping and spilling of juice.
(fig 6) Always clean the appliance immediately after each use.
7. Wrap the cord under the CitriStar base and exit cord through the opening in
the back of the appliance. If necessary, wind excess cord around. (fig. 7)
7