Filter
Top Products
ENGLISH
Use & Care Manual
7
Gas Cooktop Operation
Gas Control Knob Setting
Electric gas ignition
The gas burner use an electric ignition device located
near each burner that by means a spark igniters
ensure its surface light automatically.
Models with standard ignition
The electric ignition automatically light the surface
burners when the control knobs are turned to LITE
position.
To set:
1. Push and turn knob counter clockwise to “LIGHT”,
all four or five
spark plugs will generate a clicking
sound (spark), however only
the burner with the
control knob turned to
LIGHT will produce a flame.
2. Turn knob anywhere between Hi and LO (in this
position the sparking will stop). In case flame goes
out repeat the step 1.
Models with automatic re-ignition
The electronic auto re-ignition, lights the surface
burners when the control knob are turned at any valve
rotation that admits sufficient gas flow to support a
flame.
If any burner flame goes out due to a draft or other
adversity, the igniter automatically sparks on all
burners to relight the flame.
NOTE: this feature is provided as a convenience and
is not intended as a safety feature.
To set:
x Push and turn knob counter clockwise everywhere,
all four or five spark plugs will generate a clicking
sound (spark), however only
the
burner
with
the
control
knob
turned from HI _ LO will produce a
flame and re
ignite automatically if the flame go
es out.
WARNING
x Do not operate a burner using empty
cookware or without cookware on the grate.
x Do not touch the burner when the igniters are
clicking (sparking).
x Do not let the burner flame extend beyond the
edge of the pan.
x Turn off all controls when not cooking.
Failure to follow these instruction can result in
personal injury or fire.
Gas burners
The gas burners design of these cooktop models, allow
a pleasing option for cooking where size, power and
simmering are a primary concern.
Burners with one ring flame
These gas burner line is engineered to match a wide
size and power capacity. The use of this burner is
very simple; just push and turn the knob counter
clockwise and set to the desired position from Hi to
LO heat level (see chart guide when setting heat level).
Its ignition device can be standard or with automatic
re-ignition.
LO
LO
MED
MED
HI
HI
002