Filter
Top Products
ENGLISH
Installation Manual
7
Step 3
A foam tape is provided to seal the cooktop edges to the
countertop. Apply tape approximately 1/16” (1.5 mm)
from the glass edge to the underside of the cooktop
glass. Use tape around the entire glass perimeter. Cut
off excess where tape ends butt.
Remove the two screws from burner box, then place
the bafe as showed below xing it by the screws
removed previously.
BURNER BOX
COOKTOP GLASS
FOAM TAPE
SEAL
Figure 7.
SCREWS
BAFFLE
Figure 7b.
Step 4
Insert the cooktop centered into the cutout opening.
Make sure the front edge of the counter top is parallel
to the cooktop. Make nal check that all required
clearances are met.
Figure 8.
Step 5
Four clamp brackets are provided to clamp the cooktop
to the countertop. Tighten screws just enough to hold
brackets in place when cooktop is put into cutout.
Tighten screws securely.
Figure 9.