Filter
Top Products
— 18 —
C24EA SERIES ELECTRIC CONVECTION STEAMERS
SYMPTOMS
Steamer not steaming
Steamer not heating/
steaming properly
Door leaks
Water accumulates in
compartment
Water not being supplied
to generator
Steam is exiting from under
steamer
POSSIBLE CAUSES
No main power source
Power switch in off position
Door open
Water not being supplied to
steamer
Excessive lime build up in the
steamer
Damaged door gasket
Improper drain
Drain clogged
Damage to gasket sealing surface
Plugged drain or screen
Unit not leveled properly
Drain clogged
Water supply valve is off
Water pressure low
Water filter is plugged
Valve inlet screen clogged
Generator pressure is too high
REMEDY
Check the power source or circuit
breaker.
Press power switch to the on
position.
Close door.
Refer to symptom WATER NOT
BEING SUPPLIED TO
STEAMER.
Descale the steamer (see
REMOVAL OF LIME SCALE
DEPOSITS).
Check door gasket for damage.
If adjustment is needed, contact
your Authorized Vulcan-Hart
Servicer.
Clear compartment cavity screen.
If symptom persists, contact your
Authorized Vulcan-Hart Servicer.
See leveling instructions in the
INSTALLATION section of this
manual.
Unclog drain.
Turn valve on.
Check water supply pressure.
Refer to water filter manual. If
symptom persists, contact your
Authorized Vulcan-Hart Servicer.
Contact your Authorized Vulcan-
Hart Servicer.
Contact your Authorized Vulcan-
Hart Servicer.
TROUBLESHOOTING