Filter
Top Products
– 4 –
Installation, Operation and Care Of
MODEL GH SERIES HEAVY-DUTY GAS RANGES
SAVE THESE INSTRUCTIONS
GENERAL
Vulcan ranges and ovens are produced with quality workmanship and material. Proper installation,
usage and maintenance of your range will result in many years of satisfactory performance.
The manufacturer suggests that you thoroughly read this entire manual and carefully follow all of the
instructions provided.
INSTALLATION
UNPACKING
This range was inspected before leaving the factory. The transportation company assumes full
responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check
for possible shipping damage. If the range is found to be damaged, save the packaging material and
contact the carrier within 15 days of delivery.
Carefully unpack range(s) and place in the approximate installation position, whether as a battery or
single stand-alone range. Remove all shipping wire and wood blocking. Remove parts (packed in a
cardboard box) from oven cavity, or cabinet body or on top of modular range(s).
Before installing, check the electrical service (Convection Oven Models only) and type of gas supply
(natural or propane) to make sure they agree with the specifications on the rating plate located on the
lower left-hand corner of the front frame behind the bellcrank. If the supply and equipment
requirements do not agree, do not proceed with the installation. Contact your dealer or Vulcan-Hart
immediately.
LOCATION
CAUTION: The equipment area must be kept free and clear of combustible substances.
The following ranges, when installed, must have a minimum clearance from combustible construction
of 6" (152 mm) at the sides and 6" (152 mm) at the rear. Clearance from noncombustible construction
can be 0" (0 mm) at the sides and rear:
GH30
GH30C
GH30S
GH45
GH45C
GH45S
GH6
GH6C
GH6S
GH60
GH60C
GH60S
GH60T
GH60TC
GH60TS
GH72
GH72C
GH72S
GH72/45
GH72/45C
GH72/45S
GH60/45
GH60/45C
GH60/45S
GH60T45
GH60T45C
GH60T45S
GHX45
GHX60
GHX60T
GHX72