Filter
Top Products
INSTALLATION (continued)
WARNING
SLIPPING / FALLING
HAZARD
SPILLED OIL
DO NOT OPERATE UNLESS
THE GREASE CUP
AND TROUGH
ARE INSTALLED.
Oil and moisture will drip onto
the floor and falls may result.
Death or serious injury may
result from slipping and falling
On units with optional frypot
drains, be sure drain valves
are left in the closed position.
GREASE TROUGH AND GREASE CUP INSTALLATION
1. Install the GREASE TROUGH into the brackets below the grease
baffle.
2. Install the GREASE CUP on the right side of the unit, directly
below the grease trough.
FRYPOT INSTALLATION
1. Using the lifting handle, raise the element head. The support rod is
spring loaded and will move into place to support the head.
2. Install the frypot in the cutout beneath the element head.
3. Lift the element head slightly, then move the element support rod
forward to allow the head to lower.
4. Gently lower the element head into the frypot.
ROLL WARMER INSTALLATION
1. Install roll warmer drawers in drawer slides.
2. Place appropriate one drawer insert pan into each warmer drawer.
If used, place one Humitrol rack into each drawer pan.
Humitrol
Rack
Drawer
Insert
Pan
Fig. 8 Roll Warmer Drawer Pan Installation
12
Fig. 8a Frypot Drain Valve
Operation