Filter
Top Products
INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the hood for hidden
damage and tested it for
proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
WARNING!
RISK OF
INJURY
Installation procedures must
be performed by a qualified
technician with full knowledge
of all applicable electrical
codes. Failure can result in
personal injury and property
damage.
CAUTION!
RISK OF
INJURY AND
PROPERTY
DAMAGE
Unplug conveyor warmer and
allow to cool before beginning
installation.
IMPORTANT:
Maintain required clearances
of at least 6" between the
appliance and adjacent
combustible surfaces.
Avoid storing flammable or
combustible materials in, on
or near the appliance.
UNPACKING & INSPECTION
Carefully read all instructions in this manual before starting any
installation.
Carefully remove the hood from the carton.
IMPORTANT: Appliance weighs 92 lbs (42.7 kg). Use appropriate
care when removing from carton and installing on conveyor warmer.
Remove all protective plastic film, packing materials and accessories
from the hood before connecting electrical power or otherwise
performing any installation procedure.
Read and understand all labels and diagrams attached to the hood.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
COMPONENTS:
HIGH EFFICIENCY FILTER
CHARCOAL FILTER
COMPONENTS SHIPPED SEPARATELY
CANOPY (2 ea)
ADAPTER TOP
SETUP
The conveyor-style warmer requires an adapter top (shipped
separately) for mounting the hood. Place adapter top on warmer
before setting hood in place. Carefully place hood on top of warmer.
Orient hood so that power switch is on the same side as the power
switch of the warmer. Center hood over the body of the warmer as
shown in Fig. 2 below:
Fig. 2 Hood installation on warmer
Check high efficiency filter and charcoal filter for proper installation.
Charcoal filter slides into clips on the high efficiency filter. Airflow
marks must point "up".
Attach entry and exit canopies to pins on sides of hood. Canopies are
interchangeable and may be mounted at either end.
Maintain required clearances of at least 6" between the appliance and
adjacent combustible surfaces.
5
531 p/n 305812 OpManual for Conveyor Hood