Filter
Top Products
I
The water dispenser
Chilled water comes from a tank behind
the meat drawer. It holds approximately
1 l/2 quarts (1.5 L).
When the refrigerator is first hooked up,
press the water dispenser bar with a glass or
jar until you draw and discard 2 or 3 quarts
(1.9 to 2.8 L). The water you draw and
discard rinses the tank and pipes.
Allow several hours to chill a new tankful.
NOTE: The small tray beneath the dispenser
is designed to evaporate small spills. There is
no drain in this tray. Do not pour water into it.
To dispense water:
1. Press a sturdy glass against the water
dispenser bar.
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week
to maintain a fresh supply.
The dispenser light
To turn on night light, slide dispenser
LIGHT switch to the left. See page 21 for
directions for changing the dispenser
light bulb.
ON
Off
e .
Solving common ice dispenser problems
1 PROBLEM
POSSIBLE CAUSE/SOLUTION
Ice dispenser will
not work
l Freezer door is open.
l Ice bin not properly installed. Make sure the bin is pushed in
all the way.
l Wrong ice in bin. Only use crescents from the ice maker.
Shake the bin occasionally to separate cubes and increase
storage room.
l Dispenser not used for extended periods of time, causing ice
cubes to melt together. Dump old ice and make a new
supply-
Ice dispenser stops
working
l Ice dispenser bar held in too long. Wait about 3 minutes for
dispenser motor to reset.
l Large amounts of ice should be taken from the bin, not
through the dispenser.
13