Filter
Top Products
l If ice is not being made fast enough and
more ice is needed, turn the Refrigerator
Control toward a higher number. Wait a
day and, if necessary, turn the Freezer
Control toward C.
l Good water quality is important for good
ice quality. Try to avoid connecting the ice
maker to a softened water supply. Water
softener chemicals (such as salt from a
malfunctioning softener) can damage the
ice maker mold and lead to poor ice
quality. If a softened water supply cannot
be avoided, make sure the water softener
is operating properly and well maintained.
Solving common ice maker/dispenser
problems
PROBLEM CAUSE
SOLUTIONS
Ice dispenser
l Freezer door open
l Close the freezer door.
won’t work
l Ice bin not properly
l Make sure bin is pushed in all the way.
installed
l Wrong ice in bin
l Use only crescents from ice maker.
Shake the bin occasionally to keep cubes
separated and to increase storage room.
l Dispenser not used for
l Dump old ice and make a new supply.
extended periods,
causing ice cubes to
melt together
Ice dispenser
l Ice dispenser bar held
l Wait about 3 minutes for the dispenser
stops working
in too long
motor to reset.
l Large amounts of ice should be taken from
the bin, not through the dispenser.
Off -taste or
odor in ice
l Ice attracts airborne
l Dump old ice and make a new supply.
odors; old ice
Store excess ice in covered container.
l Water quality
l Water containing minerals (such as sulfur)
may require a filter to remove.
l Foods not properly
l Wrap properly. See pages 24 and 25.
wrapped
l Ice bin and freezer may
l Clean freezer and ice bin. See cleaning
need cleaning
chart on pages 21 and 22.
l Plumbing to ice maker
l Follow Installation Instructions for proper
ice maker water supply hookup. (See back
of refrigerator cabinet.)
l New ice maker
l The first few loads of ice from a new ice
maker may have an off-taste. Dump ice
and make a new supply.