Filter
Top Products
Before Using Your
Refrigerator
I
In This Section
I
Cleaning it ...........................................
5
Installing it properly
...........................
6
Plugging lt In .......................................
5
Leveling it
............................................
6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to
a
power source, install it and level it.
Cleaning it
Removing packaging materials
NOTE:
Do not remove any permanent
_ .
Remove tape
and
any inside
the model and serial number
using the refrigerator.
labels (except
label) before
To remove any remaining glue:
l
Rub briskly with thumb to make
a
ball, then
remove.
OR
l
Soak area with liquid handdiihwashing
detergent before removing glue as
descrii above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See “Important
Safety Instructions” on page 3.
instruction labels inside your refrigerator. Uo
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materiils,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 19-20.
Plugging it in
Recommended Grounding Method
A115Volt,60Hz.,AConly15or20ampere
fused and properly grounded eiectriil
supply is required. R is recommended that a
separate circuit sewing only this appliance
be provided. Use
a
receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
See Electrical Requirements and Ground-
ing Instructions Sheet in your Literature
Package.
&Prong grounding
type well recaptacia \
Ret rigerator
power cord
groundi
plug