Filter
Top Products
Changing the light bulb
Electrical Shock Hazard
Before removing a light bulb, either unplug
the refrigerator or disconnect the electricity
leading to the refrigerator at the main
power supply. Turning the Temperature
Control to the OFF position does not
disconnect the refrigerator from the power
supply.
Failure to do so could resuft in electrical
shock or personal injury.
To change the refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Panel to remove
bulb.
3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE: Not all commercial appliance bulbs will fit
your refrigerator. Be sure to replace a bulb with
one of the same size. wattage and shape.
Reversing the door swing
You can change the hinges on your refrigerator
so the doors open the other way. Refer to the
instruction sheet included with your refrigerator.
Saving energy
You can help your refrigerator use less electriiity.
l
Check door gaskets for a tight seal. Level the
cabinet to be sure of a good seal.
l
Clean the condenser coils regularly.
l
Cpen the door as few times as possible. Think
about what you need before you open the door.
Get everything out at one time. Keep food
organized so you won’t have to search for what
you want. Close door as soon as food is
removed.
l
Go ahead and fill up the refrigerator, but don’t
overcrowd it so air movement is blocked.
l
It is a waste of electricity to set the refrigerator
temperature colder than it needs to be. If ice
cream is firm in the freezer and drinks are as
cold as your family likes them, that’s cold
enough.
l
Make sure your refrigerator is not next to a heat
source such as a range, water heater, furnace,
radiator or in direct sunlight.
11