Filter
Top Products
Install properly...
3 inches
1 Check the strength of the floor It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 inches (7 5 cm] air space on top of freezer
for proper ventrlatlon
4 Allow at least an Inch (2.5 cm] between the
freezer condenser, on the buck of the unit, and
the wall
5 Allow ‘1. Inch (1.25 cm) on each side of the freezer
for ease of rnstallatron
6 If the freezer IS to be against a wall, you might
want to leave extra space on the hinge srde so the
door can be opened wider
7 The four bolts that held your freezer in the shipprng
crate are designed to be the levelling legs. Screw
the legs for enough into the bolt holes, in each of
the four bottom corners, so the freezer stands
about 1 Inch (2 5 cm] off the floor
-I
Level freezer...
so the door WIII stay
open at any positron
Levelling Leg
Lower
Raise
Start adjustment with the door hinge side.
1 Slide freezer into place
2 Adjust front legs to level the freezer
To rarse front, turn each leg clockwlse
~ To lower front, turn each ieg counter-clockwlse.
3 Check with level
4 After freezer is fully loaded, recheck wrth level
4
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1. Rub briskly with thumb to make a ball, then
remove
OR
2. Soak area with drshwashing detergent solutron (1
teaspoon detergent In 1 quart warm water) be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or Rammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it . . .
Clean your freezer bef
using it. See cleaning
rnstructions on page 6.
Plug it in...
3-prong grounding
type wall receptacle
Freezer
Power Cord
grounding plug
Recommended Grounding Method
A 115 Vo!t. 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired It IS recommended that a separate circuit
serving only this appliance be provrded
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See rndrvrdual electrical require-
ments and grounding instruction sheet in your Irter-
ature package