Filter
Top Products
6. After cleaning the gas tube opening and
ports, replace the burner cap and trim
ring. (Trim ring must be replaced over
burner base before replacing burner cap.
Do not operate burners without trim rings
in place.) To replace burner cap, make
sure cap is properly aligned and leveled.
Find the recessed locating tabs on the
burner cap (see illustration) and place
cap over the white ignitor in the burner
base.
7. Turn on the burner to determine if it will
light. If the burner does not light after
cleaning, contact an authorized Roper
service technician. Do not service the
sealed burner yourself.
Removing the oven door
Removing the oven door will help make it
easier to clean the oven.
Electrical Shock Hazard
Make sure all controls are OFF and the
oven is cool before removing oven door.
Failure to do so could result in electrical
shock or burns.
To remove:
1. Open the door as far as it will go.
2. Remove the screws on each side of
the oven door.
3. Close the door about % of the way.
4. Lift the door up and off the hinges.
\Q
- “1 _ -_,-’
.
.j
/
I
3
/
::.‘
c
/ Screw
0
‘3
19