Filter
Top Products
Page 3-33
3-33
Cooking Products Service Manual
Original July, 1996 4321891
© 1996 Whirlpool Corporation
REMOVING THE INNER DOOR GLASS
WARNING
8. If you are replacing the window seal, (the
rope-type seal around the metal frame), re-
move and replace it at this time.
9. Install the new inner door glass in the metal
frame.
INNER
DOOR
GLASS
METAL
FRAME
DOOR
LINER
10. Position the insulation around the metal frame.
11. Reinstall the insulation retainer in the door so
the edge is under the hinge assembly.
12. Position the arm on the hinge assembly to be
installed to the “broil stop” position, then mount
it to the oven door with its two flat-head
screws. Make sure that the tab at the top of the
hinge fits into the slot in the door liner before
you mount the screws.
13. Using the bottom of your shoe, press down on
the hinge assembly arm, and insert the pin
into the hole in the arm.
14. Mount the bottom trim to the oven door with its
mounting screws.
15. Mount the outer door glass, top trim, and the
door handle to the door.
16. Reinstall the oven door on the range.
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
1. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
2. Remove the oven door (see page 1-20 for the
procedure).
3. Remove the door handle, top trim, and outer
door glass from the oven door (see page
3-30).
4. Remove the flat-head screws from the bottom
trim and remove the trim from the oven door.
5. Remove one of the hinge assemblies from the
oven door (see page 3-31).
6. Lift the side of the insulation retainer and slide
it out from under the remaining hinge assem-
bly.
7. Fold back the door insulation, and remove the
defective inner door glass from the metal
frame.