Filter
Top Products
3-24
REMOVING THE BROIL BURNER & IGNITOR
WARNING
5. Remove the clip holding the ignitor wires to
the rear oven liner.
BROIL IGNITOR
BROIL BURNER
MOUNTING SCREWS
CLIP
MOUNTING BRACKET
QUICK–DISCONNECT PLUGS
(LOCATED BEHIND RANGE)
BACK OF
OVEN LINER
6. Remove the broil burner and ignitor assembly
screws, and pull the quick-disconnect plugs
for the ignitor through the hole at the rear of
the oven liner.
7. Disconnect the broil ignitor quick-disconnect
plug from the main harness plug.
8. Remove the broil ignitor from the broil burner
bracket.
9. Mount the new broil ignitor to the new broil
burner.
10. Mount the broil burner and ignitor assembly to
the oven.
11. Reassemble the range.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
1. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
2. Remove the oven door (see page 1-20 for the
procedure).
3. Remove the oven racks.
4. Remove the four heat shield screws and the
front broil burner screw.
HEAT SHIELD
FRONT BROIL
BURNER SCREW