Filter
Top Products
PROBLEM
Burner makes
popping noise
when on
POSSIBLE CAUSE
Burner is wet from washing.
Let dry.
SOLUTION
Control knob(s)
will not turn
Self-Cleaning
cycle will not
operate
You are not pushing in before
turning.
The range clock does not show
the correct time of day.
A delayed start time has been
programmed.
Push control knob(s) in before turning to a
setting.
Reset clock to show the correct time of
day. (See page 12.)
Wait for the start time to be reached.
Cooking results
The range is not level.
Level range. (See Installation Instruc-
are not what you
tions.)
expected
The oven temperature seems too
Adjust the oven temperature control. (See
low or too high.
“Adjusting the oven temperature control”
on page 15.)
The oven was not preheated as
Preheat oven if called for in recipe.
the recipe calls for.
The recipe has never been
Use only tested recipes from a reliable
tested or is not from a reliable source.
source.
The pans are not the type or size
Refer to a reliable cookbook for recom-
recommended in the recipe. mended pan type and size.
There is not proper air circulation
Allow 1% to 2 inches (4-5 cm) on all sides
around pan when baking.
of the pans for air circulation. There must
be a minimum space of 1 inch (2.5 cm).
Flame size does not fit the
Adjust flame size to fit cooking utensil.
cooking utensil being used.
When broiling, you have not
Completely close oven door.
completely closed the oven door.
The display is
flashing “88:88”
There has been a power failure. Reset the clock. (See page 12.)
Display beeping
and flashing error
code
“F-1 ” _ “F-1 0”
Push CANCEL. Call for service. (See
Step 3 on page 34.)
33