Filter
Top Products
VENTED KITCWEhl RANGE HOOD
FOR 120 V. OPERATION
KITCHEN
RANGE HOOD
MODEL
RH5336XL
READ AND SAVE THESE INSTRUCTIONS
Before you begin,
read the following instructions
completely and carefully. If followed, they will simplify
2. Dependtng on mounting surface, use either prepunched
the installation job.
holes In the hood flanges at the top or the mountrng brackets
included with the hood to secure the hood to the furr down. lf
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
INSTALLING DUCT WORK:
Figure
1 shows
typical installation.
The unit vents vertically only
with 3% X 10 duct.
Use Figure 2 to cut duct hole and wrrtng entrance hole In furr
down. Note control side for hood on Fig. 2. be sure thus IS the
same side as the cook top controls.
Installation under kitchen furr down:
1. For easy installation hood should be drsassembled. See fig.
5. First remove aluminum filter from fan box assembly by
pulling tab toward opposrte end of filter. Then remove blower
assembly by unpluging blower power leads and pushing
retatnlng brackets off retaining bumps. Finally, remove black
fan box assembly by removing 6 screws. (See fig. 6). Remove
hood mounting brackets from interior shipping position.
mounttng brackets are used, screw the brackets to the furr
down SIX to none Inches from the hood ends. Use the center hole
to mount the bracket tnitiallv. Leave the center screw loose
enough to rotate on the center screw. Rotate the brackets as
shown In Fig. 3, and lift the hood canopy (without black fan box
assy.) into posrtion. Rotate brackets until they are supportlng
the hood canopy. Attach remaining screws
3. Make electrical connectton in wiring tunctlon box
accordrng to the latest Natlonal ElectrIcal Code and
applicable local codes. Hood must be permanently grounded.
4. Ltft fan box assembly into position and make necessary
ductwork connectlons. Secure fan box assembly to hood
canopy with
SIX
screws.
5. Replace blower 8 filter.
NOTE:
It has been found that a large part of the energy loss of
the average home IS due to outside arr infiltrating the structure.
Seal around ductwork where it passes through outside walls or
ceiling. Seal around electrlcal wrrrng also
TOOLS AND MATERIALS REQUIRED
l
Drill, electric or ratchet drive, with l-‘,h” wood bit (to
drill an access hole in the cabinet or kitchen wall for the
electric power line.)
l
One common head screwdrtver (to secure hood
mOUntlng screws to the cabtnet and hood sheet metal
parts).
l
Plier& (for opening knockouts)
l
Pencil, ruler and level for marklng cabinet locattons.
l
Saber saw or keyhole saw for cutting the wall or cabinet
opentngs
l
Caulkrng. metal snips. duct tape, ducts (wrth elbow and
transttlon. If necessary) and wall cap or roof cap, as
required.