Filter
Top Products
I-
’ VENTLESS KITCHEN RANGE HOOD
FOR 12O.V. OPERATION
Tiiifl 01
4a
II
I
KITCHEN
RANGE HOOD
MODEL
RH7630XL
READ AND SAVE THESE INSTRUCTIONS
Betore you begin, read the following lnstructlons
completely and carefully. It followed, they will simplify
the installation job.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR’S USE
1. Remove screw holding junction box cover.
2. Remove proper electrical knockout See Figure 1.
3. Lift the hood into position. Mark location of four
mounting holes.
4. Remove hood and start all four screws in center of
narrow neck of keyhole slot marked on cabinet bottom. (Fig.
2).
5. Lift into position on four screws simultaneoulsy feeding
electrical wire through knockout.
8. Complete electrical wiring in junction box according to
the National Electrical Code and applicable Local codes.
for an easier installation, remove the filters and the three
assemblies shown in Fig. 3. This reduces the weight about
40%. The blower cover and light frame assembly are held into
place with thumb screws. To remove the blower assembly,
first unplug the blower supply cord from the junction box.
Remove the packing screw from the blower retaining rod,
then pull the blower retaining rod to one side, freeing it from
NOTE: This unit must be permanently grounded.
7. Tighten screws to secure hood. Be sure screw head is in
narrow neck of keyhole slot.
8. Replace junction box cover.
9. Replace blower cover, light frame assembly and filters.
between the bumps on the blower housing.
10. Replace blower.
TOOLS AND MATERIALS REQUIRED
l
Drill, electric or ratchet drive, with 1-W’ wood bit (to
drill an access hole in the cabinet or kitchen wall for the
electric power line.)
l
One common head screwdriver (to secure hood
mounting screws to the cabinet and hood sheet metal
parts).
l
Pliers (for opening knockouts).
l
Pencil, ruler and level for marking cabinet locations.
l
Saber saw or keyholesaw for cutting the wall or cabinet
openings.