Filter
Top Products
Before You Start . . .
IMPORTANT: Read and save these instructions.
If you need assistance.. .
It is recommended that this system be installed by a licensed plumber.
Refer to the Use & Care information at the end of this booklet. If you need more help,
It is the responsibility of the installer to comply with the
the Whirlpool Consumer Assistance Center will answer any questions you may have
installation specifications provided and with state and local
about operating or maintaining your water filtration system. The Whirlpool Consumer
plumbing codes.
Assistance Center is open 24 hours a day, 7 days
a week. Just dial l-800-253-1301-the call is free.
If you decided to install the system yourself, see “General
Information” on page 9 before continuing.
When you call, you will need the water filtration
system model number and serial number. Both
Water Filtration Svstems I. II and Ill can be installed in the basement if
numbers can be found labeled on the filtration
there is not adeqiate room for under-sink installation. Order additional
assembly.
tubing, Part No. 4319151 from your Whirlpool dealer.
DO NOT use filtration system if water is micro-
biologically unsafe or water quality is unknown.
Water Filtration
Systems I, II & 111
0
HOOK UP WATER
&Turn off cold water supply.
*Turn on faucet to drain water from line.
l
Connect saddle valve to cold water suppty.
Turn saddle valve handle clockwise until
piercing lance enters pipe and stops.
*Connect one end of orange tubing lo
saddle valve. Connect other end to
filtration assemblv.
a
‘SYSTEM CONNECTION
l
Decide if the system will be connected
to your refrigerator, to an optional faucet
or to both.
l
Connect refrigerator’s water supply to
filtration assembly with blue tubing.
l
Or, install faucet in sink and connect
connector to connect
0
START UP