Filter
Top Products
7
Dishwasher Features
Your Whirlpool dishwasher may have some or all of these features.
POWERSCOUR™ Wash Area
The POWERSCOUR™ wash area is located
at the back of the lower level rack.
NOTE: You must select the
POWERSCOUR™ wash option to use this
feature. Make sure items do not interfere
with the water feed tube, spray arms, or
POWERSCOUR™ spray jets.
■ Load pans, casserole dishes, etc. in the
back of the lower dish rack with the
soiled surfaces facing the
POWERSCOUR™ spray jets.
■ Only one row of items may face the POWERSCOUR™ spray
jets. Stacking, overlapping or nesting items will keep the
POWERSCOUR™ spray jets from contacting all of the
surfaces.
ANYWARE™ PLUS silverware basket
The ANYWARE™ PLUS silverware basket can be hung on the
door, the bottom rack, or placed inside the bottom rack.
To open the ANYWARE™ PLUS silverware basket:
Unlock the latch.
NOTE: Be sure the cover is completely latched before pulling out
the bottom rack and before closing the dishwasher door.
To remove the basket from the door:
1. Grasp the silverware basket by the handle. Slide it toward the
top of the door.
2. Lift the basket off the holding buttons.
To replace the basket in the door:
1. Set the silverware basket on the holding buttons.
2. Slide the basket toward the bottom of the door until is locks
into place.
Cup shelves
Fold down the extra shelf on the left-
hand or right-hand side of the top rack
to hold additional cups, stemware or
long items such as utensils and
spatulas.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle
If the door is opened during a cycle or the power is interrupted, the START/RESUME indicator
flashes. The cycle will not resume until the door is closed and START/RESUME is pressed.
To cancel wash
cycle
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
To follow the
progress of your
dishwasher cycle
The “Washing” indicator glows at the start of the first fill of any cycle (except Rinse Only) and
remains on until the end of the main wash cycle.
To follow the
progress of your
dishwasher cycle
The “Drying” indicator glows during the drying portion of each cycle (except Glass Xpress and
Rinse Only).
To follow the
progress of your
dishwasher cycle
The “Clean” indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the “Sanitized”
indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to
the required temperature. The light goes off when you open and close the door or press
CANCEL.