Filter
Top Products
12
SELECT LOCATION OF REVERSE OSMOSIS
FAUCET MOUNTING HOLE
You will need to select the location of the Reverse
Osmosis Faucet. You have three options to choose from:
• Use the existing sink top hole for the spray hose or
soap dispenser (Must be 1-3/8” in diameter)
• Drill a new hole in the sink
• Drill a new hole in the countertop next to the sink
1. Determine where you are going to install your Reverse
Osmosis Faucet.
2. Check to ensure the Reverse Osmosis faucet will mount
flat against the mounting surface.
3. Visually review the routing of the tubes from the
Reverse Osmosis filter assembly to the faucet. Check to
ensure there is adequate tube routing space between
the faucet and filter assembly.
3. If drilling is needed, drill a 1-3/8" diameter hole in the
mounting surface.
IMPORTANT: Drilling holes into countertops and
sinks should only be performed by a qualified
installer who is certified for drilling such materials.
Drilling of surfaces made of stone or solid surface
materials such as granite, marble, Corian™ or other
plastic resin products or sinks made of porcelain
and stainless steel may cause permanent, irrepara-
ble damage to the sink or countertop surface.
Step 5: Install RO Faucet
FIG. 13