Whirlpool WHER25 Water Dispenser User Manual


 
7
Step 1 - Install Supply Water Fitting
Questions? Visit www.ecodyne.org or call Toll Free 1-866-986-3223
FIG. 5
Saddle Valve Connection
(Included in package)
Clamp Z
Nut
Nut - tighten
if necessary
Insert
Ferrule
(Plastic)
Use to Connect
Tubing
Handle
Valve
Clamp X
Seal
CHOOSE TYPE OF WATER FITTING TO INSTALL
Locate the cold water line in the sink cabinet. It is recom-
mended, but not required, that the cold water line be soft
water. You can use the saddle valve provided with your unit
to tap into the cold water line. See Fig. 5. Or you can pur-
chase standard pipe fittings locally such as a compression
fitting. The fitting must provide a leak-tight connection to the
Reverse Osmosis 1/4" tube.
NOTE: Local code may dictate which type of water fit-
ting is used. Consult a plumber if you are not familiar
with local codes or plumbing procedures.
NOTE: Codes in the state of Massachusetts require
installation by a licensed plumber and do not permit the
use of saddle valves.
If you live in the state of Massachusetts, review plumb-
ing code 248-CMR of the Commonwealth of
Massachusetts before proceeding with the installation.
INSTALL SADDLE VALVE
(Included with your package)
This fitting will be installed on the cold water pipe. The fitting
must provide a leak-tight connection to the Reverse
Osmosis 1/4" tubing.
Complete the following steps to install the saddle valve
assembly.
1. Review Fig. 5 and familiarize yourself with all parts of the
saddle valve. This valve will self-tap a hole in copper tub-
ing or plastic pipe.
IMPORTANT: Before starting, close the hot and cold
water shutoff valves (See Figure 5).
2. If installing on iron pipe, drill a 1/8” hole for the piercing
pin.
IMPORTANT: If a battery-powered hand drill is not
available and an electric drill is used, ensure that the
drill is properly grounded.
3. Place the seal on the inside of Clamp X. See Fig. 5. Turn
the valve handle all the way out.(counter-clockwise) Be
sure the piercing pin does not stick out beyond the seal.
4. Place Clamp X and Z around the pipe. Secure in place
with two screws. Tighten both screws evenly. Do not over
tighten screws. See Fig. 5.
5. Turn the valve handle all the way in. (clockwise) This will
pierce the wall of the pipe. See Fig. 5.
6. Do not
connect the tubing to the fitting at this time. This
will occur later in the installation.
NOTE: Once the saddle valve is installed, the nut near
the handle may need to be tightened to prevent possi-
ble leaks.
Pre-Drill
1/8'' Hole
(Iron Pipe)
Cold Water
Shutoff Valve
Hot Water
Shutoff Valve